Terrain Slope
Colours terrain mesh faces by slope (angle of the face normal from vertical): binary over / under a threshold in degrees, percent or 1:X, or a gradient across the slope range of all input meshes.
Overview
Ultra-fast mesh slope analyzer using raw C# sequential array processing and safe UI automation.
Inputs (6)
- TargetMeshes (Mesh): Meshes to analyze
- ThresholdValue (Number): Threshold for slope analysis
- ThresholdMode (Integer): 0: Degrees, 1: Percentage, 2: Ratio
- Custom Colors (Colour): List of colors for gradient or binary mapping
- EnableBinaryMode (Boolean): If true, snaps to binary colors (Under/Over threshold)
- Run (Boolean): Optional. False = skip the analysis and keep showing the last results (cached). Share one toggle with the Analysis Dashboard to switch everything on/off together.
Outputs (3)
- AnalyzedMeshes (Mesh): Colored Meshes
- Dashboard Data (Text): JSON Legend Data
- Info (Text): Component information and interpretation
Method, assumptions and simplifications
The same notes appear in the component's Info output.
Method
- Each mesh is unwelded and its face normals computed; face slope θ = acos(|n.Z|), so faces wound downwards read the same as upward ones.
- ThresholdValue is converted to an angle from the chosen ThresholdMode: degrees, percent (θ = atan(p / 100)) or ratio 1:X (θ = atan(1 / X)).
- Binary mode (default): faces with θ ≤ threshold take the first Custom Colors entry, steeper faces the last (defaults light green and red).
- Gradient mode: θ is normalised between the minimum and maximum slope over all input meshes and coloured by linear interpolation through all Custom Colors; legend labels give the slope at each colour stop in the ThresholdMode unit.
- Dashboard Data reports the share of mesh surface area over the threshold over all meshes, and the average of the per-mesh area shares.
Assumptions
- Meshes are terrain with +Z up; units do not matter because slope is an angle.
Simplifications and limits
- Slope is per face, with no smoothing across neighbouring faces, so mesh noise shows as steep faces.
- Gradient colours are relative to the slope range of the run, so they are comparable between the meshes of one run but not between runs.
Workflow
- Terrain mesh (for example from Site Fetch) -> TargetMeshes; Dashboard Data -> Legend Geometry or Analysis Dashboard.